A how-to guide from Unclog.itWritten by a Red Seal plumber in British Columbia

Kitchen · 10 minutes · Updated November 2026

Garburator clogged or humming.

A garburator that hums is jammed. One that does nothing has tripped its reset. One that runs but won't drain has a blocked pipe. Three different problems, and you can tell which in ten seconds.

Which problem do you have?

What it doesWhat it meansDo this
Hums, doesn't turnSomething is wedged against the grinding plate.Switch it off right away and free the jam (below).
Nothing at allThe overload has tripped, or it has no power.Press the red reset button underneath. Then check the plug and the breaker.
Runs, but water sitsThe unit is fine. The drain after it is blocked.Treat it as a clogged sink. Kitchen sink clogged.

Free a jam

The underside of a garburator, with a hex key in the centre socket and the red reset button beside it
  1. Switch it off at the wall. If it plugs in under the sink, unplug it. Never put your hand inside, even with the power off.
  2. Find the socket. In the centre of the bottom of most units there is a six-sided hole. It takes a 1/4-inch hex key, or the small wrench that came with the unit.
  3. Work it back and forth until it turns a full circle freely.
  4. Take out what jammed it. Use tongs or pliers and a flashlight from above. Usually a bone, a fruit pit, a bottle cap or a piece of cutlery.
  5. Wait a few minutes for the motor to cool, then press the red reset button on the bottom until it stays in.
  6. Run cold water and switch it on.

Andrew's pro tip: No socket underneath? Some units don't have one. With the power off, push the plate around from above with a wooden spoon handle.

What not to put in it

A garburator is for what is left on the plate. Scraps go in the green bin.

  • Bones, fruit pits, bottle caps, cutlery
  • Grease and cooking fat
  • Coffee grounds
  • Stringy food: celery, corn husks, onion skins
  • Starchy food: potato peel, rice, pasta. It turns to paste in the trap.

Call a plumber if

  • It hums and trips the reset every time
  • Water leaks from the body of the unit
  • The sink won't drain even with the unit running

Unclog.it frees or clears a garburator from $299 in regular hours.

Sources

Questions

New garburator, and now the dishwasher won't drain. Why?

A new unit has a plug inside the dishwasher inlet. If nobody knocked it out before connecting the hose, the dishwasher has nowhere to pump to.

Should I run hot or cold water with it?

Cold, while it grinds and for about 15 seconds after. Cold water keeps fat solid so it gets chopped and carried away instead of coating the pipe.

The reset button won't stay in. What does that mean?

The motor is still hot, or it has failed. Give it ten minutes and try once more. If it pops out again, stop. That is a replacement, not a repair.

More sink help

This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.