Kitchen · Double bowl · Updated November 2026
Double sink backing up into the other side.
You run water in one bowl and it comes up in the other. That tells you exactly where the blockage is: after the two drains join.
By Andrew HendersonRed Seal Plumber
What is happening
Both bowls drain into one pipe, through one trap, into one pipe in the wall. If that shared part is blocked, water from one bowl takes the only open path left, which is up the other drain. Cleaning one bowl's drain opening does nothing, because the blockage is not there.
How to clear it
Seal one side, plunge the other. Hold a wet cloth hard over one drain, or have someone hold it. Plunge the other with a flat cup plunger. Without the cloth you are only pushing water from bowl to bowl.
Clean the trap. On a double sink the trap is under one bowl, after the cross pipe. Bucket under it, two nuts by hand. How to clean a sink trap.
Snake the wall pipe. If the trap is clean, the blockage is in the wall. How to snake a sink drain.
If one side has a garburator
Run it with cold water for a few seconds. If it hums and doesn't turn, it is jammed, and the standing water may just be that. Free the jam first. If it runs and the water goes into the other bowl, the blockage is in the shared pipe.
Call a plumber if
- Both bowls fill when the dishwasher drains
- Water comes up when nobody is using the sink
- The trap is clean and a hand auger doesn't reach the blockage
Questions
Only one bowl is slow. Where is the clog?
In that bowl's own drain: the basket strainer, the garburator, or the short pipe before the two sides join.
Can I plunge the garburator side?
Yes, with the unit switched off. Seal the other drain with a wet cloth first.
More sink help
This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.
